Difference between revisions of "3D Printing"
| Line 50: | Line 50: | ||
[[File:01 DeltaMaker.JPG|400px|thumb|left|Our Deltamaker]] | [[File:01 DeltaMaker.JPG|400px|thumb|left|Our Deltamaker]] | ||
| − | 1) Prep & slice 3D model. | + | 1) Prep & slice 3D model. |
| − | 2) Turn on printer | + | 2) Turn on printer switch on back of machine. |
| − | 3) | + | 3) [[https://familab.org/wiki/File:03_Login.PNG Login to Octoprint]] on lab network. |
URL: deltamaker.familab.org | URL: deltamaker.familab.org | ||
Username: admin | Username: admin | ||
Password: #$familab#$ | Password: #$familab#$ | ||
| − | |||
| − | + | 4) Upload Gcode to Octoprint with 'upload' button under files menu. | |
| + | |||
| + | 5) [[https://familab.org/wiki/File:05_SetHeat.PNG Preheat printhead]] under 'Temperature' tab. The Deltamaker does not have a heated bed. | ||
| + | |||
| + | 6) [[https://familab.org/wiki/File:06_CheckLayers.PNG Preview layers]] under 'Gcode Viewer' tab and check for any possible issues. | ||
| + | |||
| + | 7) Click 'Print' under state menu. | ||
| + | |||
| + | 8) Watch the magic happen... or take a nap. | ||
| + | |||
| + | 6) Print should pop off after print is complete. If it is extra adhered just pop it off with a flat paint scraper and be careful not to damage the print bed. | ||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| + | |||
| − | |||
| − | |||
| − | |||
The old 3D Printing page has been moved to [[3D Printing (archived)]] | The old 3D Printing page has been moved to [[3D Printing (archived)]] | ||
Revision as of 22:34, 6 February 2016
This page is currently under construction, please avoid full page edits while this notice is in place. Sectional edits are safe but whole page edits could create conflicts between revisions.
Contents
3DEditing Software:
3DSlicing Software
Prepping Model for Slicing
Recommended File Type: OBJ or STL
Avoid 5+ sided faces
No manifold geometry or Lamina faces (faces sharing all edges)
Check scale and orientation! Z-up & Millimeters
Slice Model to Print
!!Insert Demos for different slicer software!!
3DPrinting With The DeltaMaker
1) Prep & slice 3D model.
2) Turn on printer switch on back of machine.
3) [Login to Octoprint] on lab network.
URL: deltamaker.familab.org Username: admin Password: #$familab#$
4) Upload Gcode to Octoprint with 'upload' button under files menu.
5) [Preheat printhead] under 'Temperature' tab. The Deltamaker does not have a heated bed.
6) [Preview layers] under 'Gcode Viewer' tab and check for any possible issues.
7) Click 'Print' under state menu.
8) Watch the magic happen... or take a nap.
6) Print should pop off after print is complete. If it is extra adhered just pop it off with a flat paint scraper and be careful not to damage the print bed.
The old 3D Printing page has been moved to 3D Printing (archived)
