Difference between revisions of "Manual Lathes and Mills"
Npolanosky (talk | contribs) |
Npolanosky (talk | contribs) |
||
| Line 2: | Line 2: | ||
| − | Tom's Techniques: https://www.youtube.com/channel/UCqR9wRW2JYXOlpqiN8C0dIg | + | [[Tom's Techniques:] https://www.youtube.com/channel/UCqR9wRW2JYXOlpqiN8C0dIg] |
Keith Fenner: https://www.youtube.com/channel/UCqR9wRW2JYXOlpqiN8C0dIg | Keith Fenner: https://www.youtube.com/channel/UCqR9wRW2JYXOlpqiN8C0dIg | ||
AvE:https://www.youtube.com/channel/UChWv6Pn_zP0rI6lgGt3MyfA | AvE:https://www.youtube.com/channel/UChWv6Pn_zP0rI6lgGt3MyfA | ||
Revision as of 07:51, 17 February 2016
This page is under construction! We are working on assembling classes on machining using the lathes and mills. Until then, check out these fine youtube channels to get some starting information. They all have excellent how-to's, and even if they are not teaching a specific topic you can learn a LOT just by watching them work on a project.
[[Tom's Techniques:] https://www.youtube.com/channel/UCqR9wRW2JYXOlpqiN8C0dIg]
Keith Fenner: https://www.youtube.com/channel/UCqR9wRW2JYXOlpqiN8C0dIg
AvE:https://www.youtube.com/channel/UChWv6Pn_zP0rI6lgGt3MyfA
Clickspring:https://www.youtube.com/channel/UCworsKCR-Sx6R6-BnIjS2MA
Halligan142:https://www.youtube.com/channel/UCG0Oeg2KLMmgFzcsoCUYdeQ
Tubalcain:https://www.youtube.com/channel/UCKLIIdKEpjAnn8E76KP7sQg
ProjectsInMetal:https://www.youtube.com/channel/UCgvJYW-Mf7Nf0SrqcmebilQ
